Topology:

1. Follow the steps below to log in to your router:

 

    1.1. Use a computer connected to the PoE Switch on any LAN port

    1.2. Set up the TCP/IP Protocol to Obtain an IP address automatically mode on your computer. 

    1.3. Ensure that your computer is on the same Layer 2 network as the Gateway.

    1.4. Visit http://192.168.10.1, select the language you want to use, and then use admin for both username and password. Then click Log In.



2. Configure the WAN

 

Here we select PPPoE as an Internet connection Type.

 

Enter the username and password provided by your ISP, shown below. Do not change other settings unless it’s necessary.


    2.1. Go to Network>Interface>WAN


    2.2Select the actual bandwidth size, Click CONFIRM.


    2.3. Wait a few minutes. If it shows Internet IPv4 IP address.internet is successfully setup.


3. Configure the Wireless Network

 

Add Wireless Networks

To add wireless networks, follow the steps below.


    3.1. Go to Wireless-AP Group


    3.2. Cilck edit to change the wireless network name (SSID) and wireless password(KEY). 

    Click CONFIRM to save your settings.

    3.4.  Go to Wireless>AP List


    3.5. Select the Online APs and click to BIND APs to the default AP group


Confirmation: